(43c) Design of Novel Catalysts and Processes for CO2 Conversion from Micro to Macro-Scale | AIChE

(43c) Design of Novel Catalysts and Processes for CO2 Conversion from Micro to Macro-Scale

Authors 

Elbashir, N. - Presenter, Texas A&M University at Qatar
Dry Reforming of Methane (DRM) process has been studied extensively as it utilizes CO2 and CH4 to produce syngas, a valuable intermediate. The main challenges for industrial application are the high energy requirement, severe coking environment and low-quality syngas (H2/CO~1) produced by DRM. In this work, we use a multi-scale approach to address each of these challenges. From catalyst design using DFT and experimental verification, to Reactor Design studies and Life Cycle Analysis of the Process, we address all facets of the CO2 challenge. The talk will focus on the highlights of results of each focus area.

In DFT, using the software VASP, we have studied bi-metallic systems and their potential for DRM. By experimental validation, we have proved that in the right proportion, Cu-Ni systems are quite active and coke resistant in DRM atmosphere. Apart from bi-metallic systems, we have also investigated the effect of over-coating commercial Ni catalysts with alumina deposited by Atomic Layer Deposition (ALD). By in-situ chemisorption studies, we found that the ALD catalysts are more coke resistant and sinter-resistant than uncoated catalysts in DRM atmosphere for 40 h time-on-stream. The reaction was carried out at 650 C at atmospheric pressure.

In the reactor design area, we have investigated different reactor sequence designs. One of these is the CARGEN reactor. It consists of a two-reactor setup where the first reactor produces high quality carbon whereas the second reactor produces syngas. If a coke free operation is desired, we propose a DRM+COSORB process combination which results in a high H2/CO ratio syngas stream and a pure CO stream than can be used for production of other chemicals. From preliminary techno-economic assessments, we found that both these processes are cost competitive and have lesser carbon footprint than commercial processes. Both of these processes have now been granted patents. The talk will give highlights of these focus areas and show the benefits of the multi-scale approach followed in this project.