Guidelines for Consequence Analysis of Chemical ReleasesBookPage 58 End of third paragraph from top of page. Reference citation should be “AICHE/CCPS, 1987b, 1991, 1995b” instead of “AICHE, 1987a, 1991, 1995b.”Page 62 Middle of page. The italicized word Evaporation should be bold Evaporation to be consistent with other headings.Page 64 Equation (2.43). m (absolute viscosity) should be replaced by u (kinematic viscosity), in two places.Page 65 First line at top of page. Symbol m (absolute viscosity) should be replaced by symbol u (kinematic viscosity).Page 72 Data for Example 11. Kinematic viscosity is actually for pentane in air, rather than a physical property for air. Value should be listed under “Physical Properties of Liquid.” Numerical answer in example is correct.Page 72 Calculation of Schmidt number at bottom of page. Symbol m (absolute viscosity) should be replaced by symbol u (kinematic viscosity). Numerical answer is correct.Page 80 Stability class under 3-4 m/s wind, plus nighttime conditions, >= 3/8 cloudiness, should be E instead of D.Page 152 Under available computer codes for integrated simulators, “DNV Technica, Temecula, CA” should be “DNV, Houston, TX”, 2 places.Page 156 Figure 3.10. Duration time should be 32.4 msec, not 0.324. due to a units problem in the spreadsheet.Page 180 Calculation at bottom of page. Equal sign is missing after first parenthesis.Page 190 Middle of page. The exponent on the temperature units is missing in the Stefan-Boltzmann constant. The constant is 1.71 x 10-9 BTU/hr ft2 oR4 .Page 214 2nd paragraph under Pool Size, last sentence is missing a period.Page 215 First full sentence. The reference citation “Lees (1984)” should be “Lees (1994).”Page 222 “Point Source Model” - The beam length is determined using the wrong triangle base length. Triangle base length should be 12.5m+50m instead of 25m+50m. Subsequent calculations uses the result of the incorrect calculation therefore the final calculated thermal flux is also incorrect. Correct calculation should result with the following: X=65.6m Fp= 1.85E-5 m^-2 Ta=0.714 Er=8.70kW/m^2Page 287 Baker reference at top of page. The words April 17-21, Atlanta, GA. New York: American Institute of Chemical Engineers should not be italicized.Page 289 Reference to “Crocker, P. W.” should be “Crocker, W. P.” Spreadsheets Example 11: Figure 2.22: Kinematic viscosity is for pentane in air and should be listed under “Physical Properties of Liquid.” Numerical answer is correct.Example 21a: Figure 3.10: Units on duration are incorrect, leading to a loss of a factor of 100. Cells H31 through H40 must be multiplied by 100.