Process Safety Technical Areas

Recent studies have shown the importance of identifying near-misses to predict the probability of accidents (Meel and Seider, 2006) – and managing them to reduce the potential of accidents (Phimister et al., 2003; Cooke and Rohleder, 2006). In this paper, new methodologies involving near-miss...

An explosion occurred in the boiler room of a food processing plant as the steam generation system was coming online after a maintenance shutdown. The explosion shattered the case of the condensate return pump fatally injuring an employee, while another employee was burned by the escaping steam...

Many LOPA scenarios have an independent protection layer (IPL) credit for operator intervention to prevent or mitigate the scenario. It is often difficult for the LOPA team or other safety teams to assess if the appropriate operator response credit is being taken. To allow a more consistent...

On February 7, 2008, at about 7:15 p.m., a series of sugar dust explosions at the Imperial Sugar manufacturing facility in Port Wentworth, Georgia, resulted in 14 worker fatalities. Thirty six workers were treated for serious burns and injuries—some caused permanent, life altering conditions. The...

A combustible dust can be non-explosible, marginally explosible or severely explosible. With the exception of a few standards with a quantitative perspective (such as NFPA 68), most safety standards and regulations do not differentiate marginally explosible dusts from severely explosible dusts. As...

This research is focused on suggesting the methodology to find optimal placement for hazardous facilities and other process plant buildings using optimization theory and mapping risks. Incidents could have possible consequences from flammable gas release which can be predicted by PHAST, and the...

This paper will discuss some of the key factors that FM Global insurance engineering representatives use in evaluating combustible dust hazards at insured locations. The information is used to develop underwriting information but more importantly, it is the basis for guidance provided for the...

The methodologies in the chapter on “Dispersion Modeling” in the CCPS book Guidelines for Consequence Analysis of Chemical Releases, provide means for modeling outdoors releases at relatively long distances from a large source. At times it is necessary to model releases at relatively short...

A method for adjusting spring operated pressure relief valve (SORV) inspection intervals is presented based on hazard identification, financial risk assessment, fluid service, and comparison of the life-cycle testing costs. Intuitively, longer intervals between maintenance and proof testing should...

At first glance it may seem that organizational culture is subjective and therefore difficult to measure. Indeed, even the definition of culture falls into the soft side of process safety. This paper will show that an objective approach can be taken to survey and define process safety culture. With...